EN 50083-9 PDF
DIN EN Cable networks for television signals, sound signals and interactive services – Part 9: Interfaces for CATV/SMATV headends. Buy CEI EN CABLE NETWORKS FOR TELEVISION SIGNALS, SOUND SIGNALS AND INTERACTIVE SERVICES – PART 9: INTERFACES FOR . BS EN Cable networks for television signals, sound signals and interactive services – Interfaces for CATV/SMATV headends and similar.
|Published (Last):||28 July 2018|
|PDF File Size:||4.92 Mb|
|ePub File Size:||15.99 Mb|
|Price:||Free* [*Free Regsitration Required]|
EVS-EN – Estonian Centre for Standardisation
You can download and open this file to your own computer but DRM prevents opening this file on 5008-9 computer, including a networked server. This specification is similar to EN and EN With the signal then applied, the vertical position of the trace can be adjusted with the objective of meeting the limits of the masks.
The link is used by the interconnected ports to perform communication. Overshoots and other transients are permitted to fall into the dotted area, bounded by the amplitude levels 0,55 V and 0,6 V, provided that they do not exceed the steady state level by more than 0,05 V.
The German and the French versions of this part may use other abbreviations. While the Fibre-Channel FC supports single mode fibre, multi-mode fibre, coaxial cable and twisted pair media interfaces, this standard defines only two distinct forms of interfaces: You may experience issues viewing this site in Internet Explorer 9, 10 or The transmission uses Biphase Mark encoding.
This code provides error checking through both invalid transmission code points and the notion of ‘running’ disparity. Hence this measure is used in the recommendations below.
Electrical medium connector The required connector shall have mechanical characteristics conforming to the BNC type. The first byte received after the second K Clock recovery In the receiver the clock recovery circuit extracts the transport clock directly from the encoded data stream. Headend equipment EN Part 6: Cable television, Telecommunication, Acoustic signals, Communication networks, Fibre optics, Wire transmission telecommunicationTelevision networks, Transport layer OSIBroadcasting networks, Visual signals, Data transmission, Telecommunication systems, Packets data transmissionCoaxial cables, Open systems interconnection.
Consequently, its inverse is the rate at which sync bytes arrive. The nominal zero level for both masks should be aligned with the oscilloscope trace with no input signal.
The signals are coded in NRZ form. The system can operate, subject to certain restrictions, with a variety of optical fibres; however, performance to this specification and interoperability between vendors equipment is assured only through the use of the optical fibre specified in this subclause. Independent of the validity of the transmission characters the received transmission characters shall be used as the receiver’s current RD for the next transmission character.
Because the link and the TS are synchronous, the bit justification operation is not needed.
BS EN 50083-9:2002
Already Subscribed to this document. Each transmission character in the table Valid data character is associated with a name Dx. Transport packet data word 8 bit: Higher loss fibre may 500883-9 used for shorter fibre cable lengths.
As an example, consider a signal which passes through several re-broadcast steps, such as the one depicted in Figure A. Which packet sizes are mandatory and which are optional is specified in Table 1.
Find Similar Items This product falls into the following categories. Want access to British Standards? This clock can be multiplied up by to generate a bit rate clock. The following dates were fixed: Standards Subsctiption may be the perfect solution. All parameters shall be met over the temperature, voltage, and lifetime range of the system. For this analysis, it is assumed that the transmission clock equals the average rate expressed by the formula.
Please first verify your email before subscribing to alerts. System performance EN Part 8: This is intentional as it leaves maximum implementation flexibility for different applications.
Safety requirements EN Part 2: RD is calculated based on two subblocks: